OpenMV Motor Shield
产品信息
$20
产品描述
This motor shield provides a simple way to power OpenMV and drive low-power motors at the same time.
The official website temporarily does not support users outside China to place orders for purchase
This motor shield provides a simple way to power OpenMV and drive low-power motors at the same time. It has a 5V regulator to power both OpenMV and the motor driver, allowing you to power two low-power motors under 2A with a single battery.
For each motor, the motor driver chip requires 2 pins to set its internal H-bridge direction and an additional pin for PWM control. Therefore, once the drive direction is set, PWM control must be used for each motor.
Q: Can I use the motor shield and servo shield at the same time?
A: Yes. They use different pins.
Applications
The motor shield is perfect if you need your robot to move around.
Motor Requirements
Voltage: 6~9V
Current: Less than 2A
Power Requirements
Voltage: 6~9V
Current: Greater than the sum of maximum currents of both motors
Tutorials
引脚图
- Circuit Diagram (pdf)：motor.pdf
- Eagle Files：(motor.sch motor.brd)
- Motor Driver Chip：TB6612FNG(.pdf)
- Voltage Regulator：NCP1117(.pdf)
Length | 36mm |
Width | 27mm |
Height | 20mm |
Weight | 6g |
Voltage | 6~9V |
